Troy-bilt 47330 Manuale Utente Scaricare il pdf (Pagina 10)

10 Section 3: Features and Controls

Figure 3-S: Squeeze clutch lever against

handlebar when starting engine. Release

clutch lever slowly after engine starts.

Figure 3-6: Squeezing the clutch lever

against the handlebar causes the Idler

pulley to move away from fhe belt, taking

tension off the heft while starling the engine.

LEAF TAMPER

Use the supplied leaf tamper (Figure 3-7)

to push light, loose, bulky materials (dry

leaves, straw, and twigs) down past the

retainer flap and Into the shredder hopper

inlet.

The leaf tamper has a “stop” that prevents

the tamper end from being struck by the

rotating cutting blades. Do not force the

tamper beyond this point. Always hold it

by the handles with the “stop” facing up.

When using the leaf tamper, use either

one hand or both hands positioned on the

built-in handle grips and be sure that the

“stop” is facing up. Always position your

arms so they do not point down into the

shredder hopper opening.

Use the hook on the end of the leaf tamper

to hang the tamper on the side of the unit.

Figure 3-7: The leaf tamper (protected by

U.S. Patents to 329,737and 35,082,329).

ENGINE CONTROLS

IMPORTANT;

• The following information describing

controls on the engine should NOT be

used as engine starting instructions.

Complete engine starting and stopping

instructions are given in Section 4.

• Additional information on operating and

caring for the engine is given in the sepa

rate Engine Owner’s Manual. Please read

the Engine Owner’s Manual carefully and

save it for future reference.

• The engine does not have a throttle

speed control as the engine operating

speed has been pre-set at the factory.

Do not attempt to alter the pre-set engine

speed. Engine speed adjustments

should be performed only by an autho

rized engine dealer.

ENGINE ON/OFF ROCKER SWITCH

Before starting the engine, push the

.(JN/OFF rocker switch (Figure 3-8) to the

ON position. To stop the engine, push the

switch to the OFF position.

FUEL SHUT-OFF VALVE (IF EQUIPPED)

Before starting the engine, turn the fuel

shut-off valve (Figure 3-8) 1/4 turn from

the OFF position to the OPEN position.

After stopping engine, return valve to OFF

position.

A DANGER

Close fuel shut-off valve, when trans

porting engine, to prevent fuel leakage.

CHOKE CONTROL

Before starting the engine, move the

engine choke control (Figure 3-8) to the

CHOKE position. A warm engine requires

less choking than a cold engine.

When engine starts, first open choke

(toward RUN) until engine just begins to

run smoothly. Then open choke in small

steps, allowing engine to accept small

changes in speed and load, until choke is

fully open (in RUN).

ROPE STARTER

The engine is started by pulling out the

recoil starter handle (Figure 3-8). Detailed

instructions for operating the recoil starter

are given in Section 4.

Do not attempt to start the engine until

you have carefully read and followed all

of the instructions in this Manual and in

the separate Engine Owner’s Manual.

Choke Control ON/OFF Rocker Switch

'’'Fuel Shut-Off Valve

Rope Starter

Figure 3-8: Engine controls.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 26 27

Commenti su questo manuale

Nessun commento